I am building a 1969 superbee. At first I was building it back in factory stock condition, however after I got started I quickly changed my mind and started using some custom parts which is going to free up some nice factory used and or remanufactured parts for similar mopar vehicles. Please look for my other adds. Parts that are currently avaliable are as follows.

BUYERS PAY ALL FREIGHT CHARGES ON THE FOLLOWING PARTS!

Factory drag link powder coated in black- $50.00.
L & R TIE ROD ASSEMBLIES POWDER COATED IN BLACK- $50.00.
Manual factory steering box, glass beaded and ready for use $75.00.

All 4 fender marker light housing( no lenses) $20.00

used master cylinder and proportioning valve for non power brakes. $25.00

2 rear wheel cylinders used $ 20.00

All four brake drums and backing plates (no spindles) 50.00 ea for the rears and 75.00 ea. for the fronts.

High flow 440 ci Drivers side exhaust manifold casting number 3830800 2 these were used on cop cars and big cube truck engines. they do flow well. $25.00.


Read carefully, these remanufactured parts were purchased for a 440 ci engine and never used. The original cartons are in rough condition but the parts should be fine.

NEW IDLER ARM, MOOG P\N K7041 $25.00
NEW BALL JOINT, MOOG P\N K772 20.00

NOTE Buyers pay all freight charges on the above parts.

I can be contacted at the following address. and if you send me your ph number I will call you direct about any parts you are interested in.
edbonnie@embarqmail.com
Also parting out a 1967 chrysler 300.
Ed